Clearing Diagnostic Trouble Codes

NOTE: The DTC can also be erased with a Honda PGM Tester.




1. Connect the SCS service connector to the service check connector (2P) located on the right side of the center console.
2. Pull the parking brake lever up.
3. Turn the steering wheel to the neutral straight ahead) position.
4. Turn the ignition switch ON (II), but do not start the engine.
5. Within 4 seconds after the light comes on, turn the steering wheel to the right at least 45 degrees but not more than 90 degrees; the ATTS indicator light will go off.
6. Within 4 seconds after the light goes off, return the steering wheel to the straight-ahead driving position; the ATTS indicator light will come on.
7. Repeat step 5 and 6 one more time.
8. After few seconds, the indicator light should blink twice, then stay off. This means that the DTC is erased.

NOTE:
- Always follow these steps exactly or the DTC is not erased.
- If the ATTS indicator light blinks repeatedly, replace the ATTS control unit.

9. Turn the ignition switch OFF, and disconnect the SCS service connector.