Transmission Housing

Part 1 Of 2:

Part 2 Of 2:

Transmission Housing

Removal

1. Remove the A/T clutch pressure control solenoid valve A/B assembly.
2. Remove the countershaft speed sensor.
3. Remove the transmission housing mounting bolts (fifteen bolts), hangers, and brackets.





4. Install a 5 x 0.8 mm bolt in the reverse idler gear shaft as shown, then remove the reverse idler gear shaft/holder assembly.





5. When removing the transmission housing from the torque converter housing, move the reverse idler gear out of way of the countershaft 2nd gear in the direction shown.
6. Align the spring pin on the control shaft with the transmission housing groove by turning the control shaft.





7. Install the special tool over the mainshaft, then remove the transmission housing as shown.
8. Remove the reverse idler gear from the transmission housing.
9. Remove the countershaft 2nd gear, then slide and remove the countershaft reverse gear and the needle bearing.
10. Remove the bolt securing the shift fork, then remove the shift fork, reverse selector, reverse selector hub, and countershaft 4th gear.
11. Remove the secondary shaft sub-assembly.
12. Remove the mainshaft sub-assembly.
13. Remove the countershaft sub-assembly.
14. Remove the differential assembly.