Torque Converter Housing Bearings/Trans Housing Bearings
TORQUE CONVERTER HOUSING BEARINGSMainshaft bearing / oil seal replacement
1. Remove the mainshaft bearing and oil seal using the special tools as shown.
2. Drive in the new mainshaft bearing until it bottoms in the housing using the special tools as shown.
3. Install the new oil seal flush with the housing using the special tools as shown.
Countershaft Bearing Replacement
1. Remove the countershaft bearing using the special tool as shown.
2. Install the ATF guide plate.
3. Install the new bearing into the housing using the special tools as shown.
Secondary Shaft Bearing Replacement
1. Remove the secondary shaft bearing using the special tool as shown.
2. Install the ATF guide plate.
3. Install the new bearing into the housing using the special tools as shown.
TRANSMISSION HOUSING BEARINGS
Removal / Installation
NOTE: Coat all parts with ATF before assembly.
1. To remove the mainshaft, countershaft, and secondary shaft bearings from the transmission housing, expand each snap ring with the snap ring pliers, then push the bearing out using the following special tools and a press.
NOTE: Do not remove the snap rings unless it's necessary to clean the grooves in the housing.
Special Tools Required:
- Driver (07749 - 0010000)
- Mainshaft:
Driver Attachment, 58 mm (07JAD-PH80101)
- Countershaft and Secondary Shaft:
Attachment, 72 x 75 mm (07746 - 0010600)
2. Install the bearings in the direction shown.
3. Expand each snap ring with the snap ring pliers, and insert the bearing part-way into the housing using the special tools and a press.
4. Release the pliers, then push the bearing down into the housing until the snap ring snaps in place around it.
5. After installing the bearings verify the following:
- The snap rings are seated in the bearing and housing grooves.
- The ring end gaps are correct.