End Cover

Part 1 Of 2:

Part 2 Of 2:

Right Side Cover

END COVER
Removal





1. Remove the A/T gear position switch cover.
2. Remove the bolts securing the harness clamp (two bolts), then remove the A/T gear position switch.
3. Remove the bolts securing the end cover (fourteen bolts), then remove the cover.





4. Slip the special tool onto the mainshaft as shown.
5. Engage the park pawl with the park gear.





6. Cut the lock tabs of each shaft locknut using a chisel as shown. Then remove the locknuts and conical spring washers from each shaft.

NOTE:
- Mainshaft locknut has left-hand threads.
- Clean the old locknuts; they are used to install the press fit idler gears on the mainshaft and secondary shaft, and the park gear and bearing hub on the countershaft.

7. Remove the special tool (mainshaft holder) from the mainshaft.





8. Remove the mainshaft idler gear and the secondary shaft idler gear using a puller as shown above.
9. Remove the bearing hub using the puller from the countershaft, then remove the countershaft idler gear and bearings.
10. Remove the park gear using the puller.
11. Remove the park pawl, spring, shaft, and shaft stop.
12. Remove the park lever from the control shaft.
13. Remove the line bolts, then remove the ATF cooler lines.