Without Scan Tool
Special Tools Required: SCS Service Connector 07PAZ-00101001. Make sure the ignition switch is OFF.
MES Connector:
2. Connect the SCS service connector (A) to the MES connector (2P) (B). Do not use a jumper wire.
3. Turn the ignition switch ON (II).
4. The SRS indicator light will come on for about six seconds, and then go off. Remove the SCS service connector from the MES connector (2P) within four seconds after the light goes off.
5. The SRS indicator light will come on again. Reconnect the SCS service connector to the MES connector (2P) within four seconds after the light comes on.
6. When the SRS indicator light goes off, remove the SCS service connector from the MES connector (2P) within four seconds.
7. The SRS indicator light will blink two times indicating that the memory has been erased.
8. Turn the ignition switch OFF, and wait for ten seconds.