Procedure B: 1998-99 Accords (L4 and V6)

1. Remove the dashboard lower cover (see page 20-54 of the 1995-02 Accord Service Manual).





2. Disconnect the ignition switch harness 6P connector from the driver's under-dash fuse/relay box.

3. Remove the steering column covers (see step 4 on page 17-25 of the service manual).

4. Note how the ignition (electrical) switch harness routes to the fuse box; you'll need to route the new switch harness the same way.

5. Make sure the ignition switch is turned to LOCK (0).





6. Remove the screw from the side of the electrical switch cover.

7. Remove the screws from the electrical switch, then remove and discard the switch and its harness.

8. Install the new electrical switch with the original screws and cover. Route its harness to the fuse box the same way the discarded harness was routed.

9. Connect the 6P connector.

10. Install the steering column covers and the dashboard lower cover.





11. Center-punch a completion mark above the eighth character of the engine compartment VIN.