Reassembly

Starter Overhaul

NOTE: Use the illustration of Starter overhaul as reference for reassembly.

Starter Brush Holder Assembly:

1. Pry back each brush spring with a screwdriver, then position the brush about halfway out of its holder, and release the spring to hold it there.

Installation Of Brush Housing Onto The Armature:

2. Install the armature in the housing. Next, pry back each brush spring again, and push the brush down until it seats against the commutator, then release the spring against the end of the brush.

Starter Reassembly:

3. Install the end cover on the brush holder.