How to Access PCM

CAUTION:
- All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
- Whenever the ignition switch ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.

1. Remove the right door sill molding.
2. Pull the carpet back to expose the PCM.





3. Remove the PCM cover mounting nuts, and turn the PCM over.
4. Inspect the circuit on the PCM according to the troubleshooting flowchart with the special tools and a digital multimeter.