Reassembly

NOTE: During reassembly, grease all sliding parts





1. Install the oil seal in the shift arm cover.





2. Install the reverse lock cam.





3. Insert the select lever into the select arm, then press the spring pin into the select arm and select lever with plier.
4. Place the boot onto the shift lever.

NOTE: Turn the boot so the hole is facing down.

5. Insert the shift arm into the interlock.





6. Insert the shift lever through the shift arm and interlock.
7. Apply liquid gasket (P/N 08718-0001) to the threads of the interlock bolt, then install it into the interlock. Tighten the interlock bolt securely.





8. Align the shift arm and shift lever holes, then insert and tighten the 8 mm bolt.





9. Apply liquid gasket to the surface of the shift arm cover mating with the transmission housing as shown.

CAUTION:
- Use liquid gasket (P/N 08718-0001).
- Remove all dirt and oil from the sealing surface.
- Apply liquid gasket on the central part of the sealing surface.
- Seal the entire circumference of the bolt hole to prevent oil leakage.
- If 20 minutes have passed after applying liquid gasket, reapply it and assemble the housings.
- Refill the oil after 30 minutes after replacement.

10. Install the dowel pins.





11. Install the shift arm cover assembly.