Removal and Installation

CAUTION:
- All SRS electrical wiring harnesses are covered with yellow outer insulation.
- When disconnecting the SRS wire harness, install the short connector on the airbag, then disconnect the wire harness.
- Replace the entire affected SRS harness assembly if there is an open circuit or damage to the wiring.







1. Remove the ashtray.
Remove the console.







2. Remove the switches, coin box, air vent, and ashtray lighting bracket.







3. Remove the radio/cassette player and dash panel.
- Loosen the self-tapping screws under the radio, and remove the radio/cassette player.
- Tilt the steering column down, then remove the panel.

Button Type Control Panel:

Lever Type Control Panel:

4. Disconnect the cables at the heater assembly.
5. Remove the self-tapping screws (4), pull out the heater control panel, disconnect the wire harness connectors, then remove the heater control panel.
6. Install in the reverse order of removal, reconnect the cables, making sure they are properly adjusted.