A. Torque Converter Housing

INSTALL OR CONNECT

- Tools Required:
- J 35552 Differential Side Bearing Race Installer
- J 8092 Driver Handle
- J 35553 Differential Side Bearing Seal Installer
- J 37274 Countershaft Bearing Installer





1. Right differential side bearing selective shim and race into torque converter housing using a J 35552 with a J 8092.
2. New right drive axle shaft fluid seal into torque converter housing using a J 35553 and a hammer.
3. New countershaft lubrication seal into countershaft front roller bearing bore.





4. Countershaft front roller bearing into torque converter housing using a J 37274 with a J 8092 and a hammer.





5. Countershaft front roller bearing retainer into torque converter housing; secure with one bolt.
- Tighten countershaft front roller bearing retainer bolt to 17 Nm (13 ft. lbs.).
6. Two fluid pipes into torque converter housing.





7. Three fluid pipe clamps into torque converter housing; secure with three bolts.
- Tighten fluid pipe clamp bolts to 5 Nm (44 ft. lbs.).