First and Reverse Brake Piston

REMOVE OR DISCONNECT

- Tools Required:
- J 23327 Clutch Spring Compressor
- J 35683 First/Reverse Clutch Spring Compressor Adapter





1. Compress return springs with a J 23327 clutch spring Compressor and a J 35683 clutch spring compressor adapter and remove spring retainer snap ring.
2. Spring retainer and springs.





3. Piston with compressed air.
4. O-rings from piston.

Inspect
- Sealing surfaces for burrs or imperfections. Repair or replace piston if necessary.

INSTALL OR CONNECT

- Tools Required:
- J 23327 Clutch Spring Compressor
- J 35683 First/Reverse Clutch Spring Compressor Adapter

1. New O-rings on piston.
2. Coat the O-ring with ATF.
3. Piston in transaxle case. Push the piston into the bore of the case facing the spring seats upward.
4. Piston return spring assembly, using a J 3568 spring compressor adapter and a J 23327 clutch spring compressor.
5. Compress piston return springs to allow installation of snap ring.
6. Snap ring.
- Push the ring into place with your fingers. Visually check to make sure it is fully seated and centered by the three lugs on the spring retainer. Be sure the end gap of snap ring is not aligned with the spring retainer.