Cylinder Head - Assembly

INSTALLATION
1. New valve guide to cylinder head.
2. Valve spring seat to cylinder head.





3. New oil seal to valve guide. After applying engine oil to oil seal and spindle of Valve Guide Remover/Installer, fit oil seal to spindle, and then install oil seal to valve guide by pushing Valve Guide Remover/Installer by hand. After installing, check to be sure that oil seal is properly fitted to valve guide.

CAUTION: When installing, never tap or hit the Valve Guide Remover/Installer with a hammer. Install oil seal to guide by pushing the Valve Guide Remover/Installer by hand only. Tapping or hitting tool may cause damage to the oil seal.

4. Valve to valve guide. Before installing valve to valve guide, bore and valve stem.





5. Valve spring and valve spring retainer. Each valve spring has large-pitch end (top) and small-pitch end (bottom). Be sure to position valve spring in place with its small-pitch end facing the bottom (valve spring seat side).
6. Using a Valve Spring Compressor and Valve Spring Compressor Adapter, compress valve spring and fit two valve cotters into groove provided on the valve stem.
7. Remove the Valve Spring Compressor and Valve Spring Compressor Adapter.
8. Camshaft to cylinder head. After applying engine oil to camshaft journal and around all cams, slide camshaft into cylinder head from flywheel end of cylinder head.
9. Rocker arms, springs, and rocker arm shafts to cylinder head; secure with ten screws. Tighten rocker arm shaft screws to 25 Nm. (18ft. lbs.).