Speedometer Gear, M/T: Service and Repair

REMOVE OR DISCONNECT

^ Tools Required:
- J 34839 Pylon Bearing Remover
- J 37764 Slide Hammer Adapter
- J 23907 Slide Hammer

1. Slide the speedometer driven gear case boot up the speedometer cable and off the speedometer
2. Speedometer cable retaining clip and speedometer cable from speedometer driven gear case.
3. One bolt and speedometer driven gear case from transaxle.
4. Speedometer driven gear case roll pin from speedometer driven gear case using standard drift punch.





5. Speedometer driven gear from speedometer driven gear case.
6. Speedometer driven gear case Oaring from speedometer driven gear case.





7. Speedometer driven gear case lip seal from inside of speedometer driven gear case using J 34839 in conjunction with J 37764 and J 23907.

Inspect
- Speedometer driven gear for excessive wear or damage.
- Speedometer driven gear case O-ring for cuts or damage.

INSTALL OR CONNECT

^ Tools Required:
- J 34857 Gearshift Shaft Seal Installer
- J 36850 Transjel (tm) Transmission Assembly Lubricant

1. Apply J 36850 to the new speedometer driven gear lip seal.





2. New speedometer driven gear lip seal into speedometer driven gear case using J 34857.
3. Speedometer driven gear case Oaring onto speedometer driven gear case.
4. Apply J 36850 to the speedometer driven gear case O-ring.
5. Speedometer driven gear into speedometer driven gear case.
6. Speedometer driven gear case roll pin into speedometer driven gear case using standard drift punch.
7. Speedometer driven gear case into transaxle; secure with one bolt.

Tighten
- Speedometer driven gear case retaining bolt to 7 N.m (62 lb. in.).

8. Speedometer cable into speedometer driven gear case; secure with speedometer cable retaining clip.
9. Slide speedometer driven gear case boot down speedometer cable and over speedometer driven gear case.