With Composite Headlamps

Composite Headlamp Assembly (LSI Model):

CAUTION: Halogen bulbs contain a gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:
^ Turn the lighting system off and allow the bulb to cool before changing bulbs. Leave the lighting system off until bulb change is complete.
^ Always wear eye protection when changing a halogen bulb.
^ Handle the bulb only by its base; avoid touching the glass.
^ Do not drop or scratch the bulb.
^ Keep moisture away from the bulb.
^ Place the used bulb in the new bulb's carton and dispose of it properly.
^ Keep halogen bulbs out of the reach of children.

Remove or Disconnect
1. Negative (-) battery cable.
2. Three screws and composite headlamp housing/parking lamp assembly from vehicle. (Figure 10).
3. Loosen composite headlamp bulb locking ring by rotating counterclockwise
4. Pull bulb from composite headlamp housing.
5. Socket from composite lamp assembly.
6. Bulb socket electrical connector.

Install or Connect
1. Bulb socket electrical connector.
2. Socket to composite lamp assembly.
3. Locking ring and composite headlamp bulb to housing; secure it by rotating clockwise.
4. Composite headlamp housing/parking lamp assembly to vehicle; secure with three screws.
5. Negative (-) battery cable.

Adjust
Composite headlamp aim.