Clearing Diagnostic Trouble Codes

^ The DTCs in Electronic Brake Control Module (EBCM) memory are erased in one of two ways:
- Tech 2 scan tool.
- Ignition cycle default.

These two methods are detailed below. Be sure to verify proper system operation and absence of DTCs when the clearing procedure is completed. The EBCM will not permit DTC clearing until all DTCs have been displayed. Also, DTCs cannot be cleared by unplugging the EBCM, disconnecting the battery cables, or turning the ignition switch to LOCK position (except on an ignition cycle default).

Scan Tool Method
When using a Tech 2 scan tool, select Diagnostic Trouble Codes (DTC) from the Chassis Menu. Then, select Clear DTC Information. A Tech 2 scan tool will remind the user that all DTC data will be erased.

For other scan tools, refer to their manufacturer's user manual for instructions.

Drive Cycle Default
When a DTC does not reoccur for 100 drive cycles, it will be automatically cleared from the EBCM memory.

A drive cycle occurs when the ignition is turned to ON and the vehicle is driven faster than 16 km/h (10 mph).

A drive cycle also occurs if a DTC sets when the ignition key is turned to ON, regardless of vehicle speed.