Ignition Coil: Service and Repair
IGNITION COIL REPLACEMENTREMOVE OR DISCONNECT
1. Distributor from vehicle. Refer to Distributor Replacement
Removing Rotor:
2. Rotor from distributor housing.
3. Ignition coil dust cover and gasket from distributor housing.
Ignition Coil Terminal Nuts:
4. Two nuts and four wires from ignition coil terminals.
Ignition Coil Screws:
5. Four screws and ignition coil from distributor housing.
INSTALL OR CONNECT
1. Ignition coil to distributor housing; secure with four screws.
2. Four wires to ignition coil terminals; secure with two nuts.
NOTICE: When connecting the wires to the ignition coil, insert them properly into their grooves found on the side of the ignition coil and make sure the wires do not come in contact with the signal rotor or distributor housing.
Tighten ignition coil terminal nuts to 8 Nm (71 lb. in.).
3. Ignition coil dust cover and new gasket to distributor housing.
4. Rotor to distributor housing.
5. Distributor to vehicle. Refer to Distributor Replacement.