Fan Shroud: Service and Repair

Cooling Fan Motor and Shroud

Cooling Fan and Shroud (View 1 of 2)










Cooling Fan and Shroud (View 2 of 2)









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. If equipped, detach the 2 block heater wiring retainers from the cooling fan motor and shroud.

3. Remove the splash shield.





4. Detach the lower radiator hose pin-type retainer from the cooling fan motor and shroud.

5. Remove the battery tray.

6. Remove the 2 bolts and position the auxiliary relay box aside.
- To install, tighten to 8 Nm (71 lb-in).


7. Detach all the wiring harness retainers from the cooling fan and shroud.

8. Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.

9. Disconnect the cooling fan electrical connector.

10. NOTE: LH shown, RH similar.
Release the 2 tabs and remove the cooling fan motor and shroud.






11. To install, reverse the removal procedure.