Rear Suspension

Shock Absorber









Removal

NOTICE: Suspension fasteners are critical parts that affect performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

1. Using a suitable jackstand, support the rear axle.

2. Remove and discard the two shock absorber upper bolts.
- To install, tighten the new bolts to 25 Nm (18 lb-ft).






3. Remove and discard the shock absorber lower bolt and remove the shock absorber.
- To install, tighten the new bolt to 115 Nm (85 lb-ft).






4. NOTICE: Tighten the shock absorber lower bolt while the suspension is at curb height or bushing damage and incorrect clamp load may occur.

To install, reverse the removal procedure.