Cylinder Head Assembly

Cylinder Head

Install the cylinder head gasket, cylinder head and 10 new bolts. Tighten the bolts in the sequence shown in 4 stages:
Stage 1: Tighten to 5 Nm (44 lb-in).
Stage 2: Tighten to 15 Nm (133 lb-in).
Stage 3: Tighten to 35 Nm (26 lb-ft).
Stage 4: Turn 75 degrees.







Bolt re-usability

NOTE: The cylinder head bolts are torque-to-yield and must not be reused. New cylinder head bolts must be installed.





Surface Variation -- Head-to-block, Head-to-manifolds And Surface Variation -- Warpage














a No. 3 Journal - Supported by No. 1 and No. 5 journals.

Camshaft Bearing Cap

Tighten the bolts in the sequence shown in 6 stages.
Stage 1: Tighten the bolts evenly, half a turn at a time, until the camshaft bearing caps and the VCT (Variable Camshaft Timing) bridge are seated against the cylinder head.
Stage 2: Tighten bolts 1 through 16 to 7 Nm (62 lb-in).
Stage 3: Tighten bolts 17 through 20 to 10 Nm (89 lb-in).
Stage 4: Tighten bolts 1 through 16 an additional 45 degrees.
Stage 5: Tighten bolts 17 and 19 an additional 70 degrees.
Stage 6: Tighten bolts 18 and 20 an additional 53 degrees.







Intake Manifold Specifications

Exhaust Manifold Specifications

Camshaft Gear/Sprocket Torque Specifications