Output Shaft Seal

Output Shaft Seal

















Removal

1. With the vehicle in PARK, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the driveshaft. For additional information, refer to Driveshaft Service and Repair.

3. NOTE: The output shaft flange nut has been staked to prevent it from coming loose. Prior to removing the nut, remove the stake to prevent damage to the output shaft.

Remove and discard the output shaft flange nut.





4. Remove the output shaft flange.





5. Using the Input Shaft Oil Seal Remover and Slide Hammer, remove and discard the output shaft seal.





Installation

1. Position a new output shaft seal.





2. Using the Rear Seal 4X2 Installer, install the output shaft seal.





3. Inspect the output shaft flange seal for damage and install a new seal if damaged. Install the output shaft flange.





4. Install a new output shaft flange nut.
- Tighten to 80 Nm (59 lb-ft).

- After installing the new output shaft flange nut, it must be staked at the slots to prevent it from coming loose.





5. Install the driveshaft. For additional information, refer to Driveshaft Service and Repair.

6. Fill and check the transmission fluid. For additional information, refer to Transmission Fluid Level Check Transmission Fluid Level Check.