Removal and Replacement

Flexplate





Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the automatic transmission. For additional information, refer to Automatic Transaxle/Transmission - 6R80 Removal.

3. Remove the 8 bolts and the flexplate.

Installation

1. NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

Install the flexplate and the 8 bolts and tighten in sequence shown.

- Tighten to 80 Nm (59 lb-ft).





2. Install the automatic transmission. For additional information, refer to Automatic Transaxle/Transmission - 6R80 Automatic Transaxle/Transmission - Installation.

3. After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.