Spark Plugs

Spark Plugs

Removal and Installation

1. Remove the ignition coil-on-plugs. For additional information, refer to Ignition Coil-On-Plug Ignition Coil-On-Plug.

2. NOTICE: Only use hand tools when removing or installing the spark plugs, or damage may occur to the cylinder head or spark plug.

NOTE: Use compressed air to remove any foreign material from the spark plug well before removing the spark plugs.

NOTE: If an original spark plug is used, make sure it is installed in the same cylinder from which it was taken. New spark plugs can be used in any cylinder.

Remove the 8 spark plugs.

- To install, tighten to 18 Nm (159 lb-in).

3. Inspect the spark plugs. Install new spark plugs as necessary. For additional information, refer to Engine.

4. Adjust the spark plug gap as necessary.





5. To install, reverse the removal procedure.