Compressor To Condenser Discharge Line

Compressor to Condenser Discharge Line













Removal and Installation

1. Recover the refrigerant.

2. Remove the 8 upper radiator air deflector pin-type retainers and remove the air deflector.

3. Remove the condenser inlet fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).

4. Disconnect the A/C pressure transducer electrical connector.

5. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).

6. Remove the compressor-to-condenser discharge line.

7. To install, reverse the removal procedure.
- Install new gasket seals and O-ring seals.

- Add the correct amount of clean PAG oil to the refrigerant system. For additional information, refer to the Refrigerant Oil Adding procedure.

8. Evacuate, leak test and charge the refrigerant system.