Oil Level Indicator and Tube

Oil Level Indicator and Tube













Removal and Installation

1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Vehicle Jacking and Lifting. Failure to follow the instructions may result in serious personal injury.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold - LH Exhaust Manifold - LH.

3. Remove the oil level indictor.

4. Remove the bolt and the oil level indicator tube.
- To install, tighten to 10 Nm (89 lb-in).

5. NOTICE: Failure to lubricate the O-ring seal and the oil level indicator tube-to-engine block mating surface with clean engine oil may result in engine oil leaks.

NOTICE: Make sure the O-ring seal remains in position and does not roll up the indicator tube during installation or engine oil leaks may occur.

Remove the O-ring seal and discard.

6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Vehicle Jacking and Lifting. Failure to follow these instructions may result in serious personal injury.

To install, reverse the removal procedure. If equipped with a fire suppression system, repower the system.
- Lubricate the new O-ring seal and engine mating surface with clean engine oil.