Compressor to Condenser Discharge Line

Compressor to Condenser Discharge Line













Removal and Installation

1. Recover the refrigerant. Service and Repair

2. Remove the rear A/C compressor bolt.
- To install, tighten to 25 Nm (18 lb-ft).

3. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).

4. Disconnect the A/C pressure transducer electrical connector.

5. Remove the condenser inlet fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).

6. Remove the compressor-to-condenser discharge line.

7. To install, reverse the removal procedure.
- Install new gasket seals and O-ring seals.

- Add the correct amount of clean PAG oil. Service and Repair

8. Evacuate, leak test and charge the refrigerant system. Service and Repair
Component Tests and General Diagnostics