Flywheel

Flywheel

Removal

1. Remove the clutch.

2. Remove the 6 flywheel bolts.

3. NOTICE: The flywheel has a pressed fit on the crankshaft pilot. Do not use screwdrivers or prybars to remove the flywheel or damage to the flywheel or engine may occur.

Remove the flywheel.

- Install 2 of the removed flywheel bolts in the 2 holes shown on the flywheel flange.

- Tighten the 2 bolts evenly to push the flywheel off the crankshaft pilot.





Installation

1. Position the flywheel on the crankshaft pilot and start the 6 flywheel bolts.

2. Tighten the flywheel bolts evenly in the sequence shown to fully seat the flywheel on the crankshaft pilot.
- Tighten to 80 Nm (59 lb-ft).