Transaxle Rear Support Insulator

Transaxle Rear Support Insulator

Transaxle Rear Support Insulator:

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the roll restrictor bolt at the subframe.
^ To install, tighten to 70 Nm (52 ft. lbs.).
3. Remove the roll restrictor bolt from the transaxle bracket.
^ To install, tighten to 70 Nm (52 ft. lbs.).
4. Remove the roll restrictor.
5. To install, reverse the removal procedure.