Transaxle LH Support Insulator
Transaxle LH Support InsulatorSpecial Tool(s)
Special Tool(s):
1. Remove the battery. For additional information, refer to Battery.
2. Release the 2 wiring harness pushpins, then remove the 3 battery tray nuts and the battery tray.
^ To install, tighten to 12 Nm (9 ft. lbs.).
3. Disconnect the intake air hose.
1 Disconnect the crankcase ventilation hose.
2 Disconnect the booster bleed hose.
3 Loosen the clamp and disconnect the intake air hose.
4. Remove the 2 resonator bolts and the resonator and intake air hose assembly.
^ To install, tighten to 11 Nm (8 ft. lbs.).
5. Disconnect the PCM electrical connectors.
6. Remove the 3 PCM/battery support bracket bolts and the pushpin retainers.
^ Remove the PCM and PCM/battery support bracket as an assembly.
7. Install the special tools.
8. Remove the 5 LH transaxle support insulator nuts and the LH transaxle support insulator with the PCM/battery support bracket.
^ To install, tighten the center nut to 150 Nm (111 ft. lbs.).
^ To install, tighten the outer nuts to 48 Nm (35 ft. lbs.).
9. If necessary, remove the 3 bolts and the LH transaxle support insulator bracket.
^ To install, tighten to 80 Nm (59 ft. lbs.).
10. To install, reverse the removal procedure.