Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor

Material

Material:

Turbine Shaft Speed (TSS) Sensor (Part 1):

Turbine Shaft Speed (TSS) Sensor (Part 2):

Removal

1. Remove the battery tray. For additional information, refer to Battery.
2. Remove the air cleaner assembly.
1 Disconnect the crankcase ventilation hose.
2 Disconnect the air cleaner outlet hose.
3 Remove the bolts and pull out the air cleaner resonator.





3. NOTE: The resonator is plugged into the bracket.

Remove the air cleaner intake hose with the resonator.





4. Disconnect the turbine shaft speed (TSS) sensor electrical connector.





5. Remove the TSS sensor bolt and sensor.
^ Check the TSS sensor bore.





6. Inspect the O-ring seal for nicks or cuts; install a new O-ring if necessary.





Installation

1. Apply a light coat of clean transmission fluid to the O-ring seal before installation.





2. NOTE: Apply thread sealer to the bolt.

Install the TSS sensor and bolt.
^ Tighten to 10 Nm (89 inch lbs.).





3. Connect the TSS sensor electrical connector.





4. NOTE: The resonator is plugged into the bracket.

Install the air cleaner intake hose with the resonator.





5. Install the air cleaner assembly.
1 Connect the crankcase ventilation hose.
2 Connect the air cleaner outlet hose.
3 Position the air cleaner into the resonator and install the bolts.





6. Install the battery tray. For additional information, refer to Battery.