Side Impact Sensor - Front Door

SIDE IMPACT SENSOR - FRONT DOOR

Removal and Installation







WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraints system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- RH shown, LH similar.

1. Depower the SRS.
2. Remove the front door trim panel.
3. Disconnect the side impact sensor electrical connector.
4. Remove the bolt and side impact sensor.
- To install, tighten to 2 Nm (18 lb-in).

5. To install, reverse the removal procedure.
6. Repower the SRS.