Air Bag Deactivation Indicator: Service and Repair

PASSENGER AIR BAG DEACTIVATION (PAD) INDICATOR







Removal and Installation

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Depower the SRS.
2. Remove the instrument panel center finish panel.
3. Disconnect the passenger air bag deactivation (PAD) indicator electrical connector.
4. Disengage the locking tangs and remove the PAD indicator from the instrument panel center finish panel.







5. To install, reverse the removal procedure.
6. Repower the SRS.