Throttle Body: Service and Repair

THROTTLE BODY







Removal and Installation

1. CAUTION: Throttle body (TB) bore and plate area have a special coating and cannot be cleaned, or possible damage to the TB can occur.

Loosen the 2 clamps and position aside the air cleaner outlet pipe.
- To install, tighten the clamps to 4 Nm (35 lb-in).







2. Disconnect the electronic throttle control electrical connector.

3. Remove the 4 bolts and the TB.
- Inspect the TB gasket and install new as necessary.
- To install, tighten to 10 Nm (89 lb-in) in the sequence shown.







4. To install, reverse the removal procedure.