Fog/Driving Lamp: Service and Repair

FOG LAMP







Removal and Installation

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Release the tabs and remove the fog lamp bezel from the front bumper cover.
3. Remove the 4 screws and the fog lamp.
- Disconnect the fog lamp electrical connector.
- To install, tighten to 1.5 Nm (13 lb-in).

4. To install, reverse the removal procedure.
- If necessary, adjust the fog lamps.