Seat - Front

SEAT - FRONT







Removal and Installation

WARNING:
- Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
- Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.
- Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Depower the SRS.
2. Remove the 2 seat-to-floor rear bolts.
- To install, tighten to 35 Nm (26 lb-ft).

3. Remove the seat track trim cover.
4. Remove the seat-to-floor front bolt.
- To install, tighten to 35 Nm (26 lb-ft).

5. Remove the seat-to-floor front nut.
- To install, tighten to 35 Nm (26 lb-ft).

6. Tip the seat rearward and disconnect the seat harness electrical connector.
7. To install, reverse the removal procedure.
8. Repower the SRS.