Roof Opening Panel

ROOF OPENING PANEL

Exploded View

Part 1:

Part 2:

Removal

1. NOTE: Make sure the roof opening panel is in the closed position.

Remove the headliner.

2. Disconnect the 2 front and the 2 rear drain hoses from the roof opening panel.
3. Disconnect the roof opening panel motor electrical connector.
4. Remove the 12 bolts and the roof opening panel.
- With the aid of an assistant, compress the legs of the roof opening panel retaining clip and lower the roof opening panel.

Installation

1. NOTE:
- The roof opening panel must be correctly located on the retaining clip before tightening the roof opening panel bolts.
- Do not fully tighten the roof opening panel frame bolts at this stage.

Compress the legs of the roof opening panel retaining clip and install the roof opening panel.
- Loosely install the 12 bolts.

2. Tighten the 12 roof opening panel frame bolts in the sequence shown.
- Tighten to 9 Nm (80 lb-in).







3. Connect the roof opening panel motor electrical connector.
4. Connect the 2 front and the 2 rear drain hoses to the roof opening panel.
5. Install the headliner.
6. Initialize the roof opening panel motor.