Headliner: Service and Repair

HEADLINER

Removal and Installation

All vehicles
1. Remove the LH and RH A-pillar trim panels.
2. Disconnect the electrical connector located at the RH A-pillar.
- Detach the 4 wire harness pin-type retainers.

3. Remove the front passenger seat.

2 door
4. Remove the driver seat.

All vehicles
5. Remove the LH and RH B-pillar trim panels.

2 door
6. Remove the LH and RH C-pillar trim panels.

4 door
7. Remove the LH and RH quarter trim panels.

All vehicles

8. CAUTION: To prevent damage to the garment hanger retainer, use a 3/16-inch flat blade screwdriver for this step.

NOTE: The garment hanger is shown without the roof sheet metal to show the metal retainer clip. The metal retainer clip will remain engaged in the sheet metal after the garment hanger is removed.

Remove the 2 garment hangers.
1 Open the garment hanger access cover.
2 Insert the flat-blade screwdriver fully into the garment hanger slot.
3 Rotate the screwdriver 90 degrees so that the screwdriver spreads the metal retainer clip. Remove the plastic garment hanger.

9. If equipped, remove the roof opening panel trim ring.
- To install, the roof opening panel trim ring ends should meet at the rear of the roof opening and have no gaps or overlaps.

10. Remove the LH and RH sun visors.
- Remove the 4 sun visor screws.

11. CAUTION: Support the headliner when removing the 2 sun visor clips to avoid damage to the headliner.

Remove the LH and RH sun visor clips.
- Remove the 2 sun visor clip screws.

12. Remove the 2 headliner push-pin retainers.

2 door

13. CAUTION: An assistant is required when removing the headliner from the vehicle to avoid damage to the headliner.

Remove the headliner.
- Lower the headliner.
- Remove the headliner through the passenger door opening.

4 door

14. CAUTION: An assistant is required when removing the headliner from the vehicle to avoid damage to the headliner.

Remove the headliner.
- Lower the headliner.
- Remove the headliner through the RH rear passenger door opening.

All vehicles
15. To install, reverse the removal procedure.