Selector Mechanism
Selector MechanismSpecial Tool(s):
Material:
1. Remove the battery.
2. Remove the bolts and the battery tray.
^ To install, tighten to 12 Nm 9 (ft. lbs.).
3. Remove the intake air hose.
1. Disconnect the crankcase ventilation hose.
2. Loosen the clamps.
^ To install, tighten to 4 Nm (35 inch lbs.).
3. Remove the intake air hose.
4. Remove the bolts and the resonator.
^ To install, tighten to 11 Nm (8 ft. lbs.).
5. Install the special tools.
6. Remove the nuts and the rear engine mount.
^ To install, tighten the center nut to 133 Nm (98 ft. lbs.).
^ Tighten the outer nuts to 48 Nm (35 ft. lbs.).
7. Remove the 3 bolts and the rear engine mount bracket.
^ To install, tighten to 80 Nm (59 ft. lbs.).
8. Disconnect the reverse lamp switch electrical connector.
9. Pressing the locking tab, disconnect the gearshift cables from the transaxle.
^ Disconnect the shift cable and the selector cable from the shift mechanism.
10. NOTE: Make sure the transaxle is in the NEUTRAL position.
Position the transaxle in the NEUTRAL position. Remove the 6 bolts and the gearshift mechanism.
^ To install, tighten the bolts in a star pattern to 23 Nm (17 ft. lbs.).
11. To install, reverse the removal procedure.
^ Apply a bead of gasket maker to the seating surface.
^ Adjust the gearshift cables.