Ignition Switch: Service and Repair
Ignition SwitchIgnition Switch:
Removal and Installation
1. Depower the supplemental restraint system (SRS). For additional information, refer to Air Bag Systems.
2. Remove the 4 bolts, release the fastener and position the instrument panel lower panel aside.
^ To install, tighten to 9 Nm (80 inch lbs.).
3. Disconnect the hood release cable and the data link connector (DLC) from the instrument panel lower panel and remove the panel.
^ Loosen the hood release cable nut.
^ To install, tighten to 20 Nm (15 ft. lbs.).
4. Remove the steering column upper shroud.
^ Using a suitable tool, release the 2 clips (one on each side).
5. If equipped, remove the audio control switch.
^ Using a suitable tool, release the locking tab.
^ Disconnect the electrical connector.
6. Remove the steering column lower shroud.
1. Release the steering column locking lever.
2. Remove the screws.
7. Disconnect the ignition switch and the LH multi-function switch electrical connectors.
8. Remove the ignition switch.
^ Release the clips.
9. To install, reverse the removal procedure.