Water Pump: Service and Repair

Coolant Pump

Material:

Removal and Installation
1. Remove the accessory drive belt.
2. Drain the cooling system.
3. Remove the 3 coolant pump pulley bolts and the pulley.
^ To install, tighten to 25 Nm (18 ft. lbs.).
4. Remove the 3 coolant pump retaining bolts and the coolant pump.
^ To install, tighten to 10 Nm (89 inch lbs.).

5. NOTE: Install a new coolant pump O-ring and lubricate with clean engine coolant.

To install, reverse the removal procedure.





6. Fill and bleed the cooling system.