Brake Caliper Anchor Plate, Rear

Brake Caliper Anchor Plate





Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the park brake cable from the brake caliper.
1 Pull back the parking brake lever.
2 Disconnect the cable from the parking brake lever.
3 Remove the cable conduit retaining clip.
4 Remove the park brake cable from the brake caliper.





3. CAUTION: Do not allow the brake caliper to hang from the hose or damage to the hose can occur.

Remove the 2 brake caliper guide pin bolts and position the caliper aside.
^ Support the brake caliper with mechanic's wire.
^ To install, tighten to 35 Nm (26 ft. lbs.).
4. Remove the brake pads.
5. Remove the 2 brake caliper anchor plate bolts and the anchor plate.
^ To install, tighten to 55 Nm (41 ft. lbs.).
6. To install, reverse the removal procedure.