Throttle Body: Service and Repair

THROTTLE BODY







Removal and Installation

CAUTION: The throttle body bore and plate area have a special coating and cannot be cleaned.

1. Disconnect the battery ground cable.
2. Remove the air cleaner outlet pipe.
3. Disconnect the throttle position (TP) sensor electrical connector.
4. Disconnect the electronic throttle control electrical connector.

5. NOTE: Discard the throttle body gasket.

Remove the 2 bolts, 2 nuts and the throttle body.
- To install, tighten to 10 Nm (89 lb-in).

6. To install, reverse the removal procedure.