Front Bumper Reinforcement: Service and Repair

FRONT BUMPER

Part 1:

Part 2:

Exploded View

Removal and Installation
1. Remove the front bumper cover.
2. Remove the 4 front bumper isolator pin-type retainers and the front bumper lower outer and upper center inner isolators.
3. Drill out the 6 front bumper spot welds.
4. Remove the bolts and the front bumper.
- 8 required (vehicles built before 12/2005).
- 6 required (vehicles built after 12/2005).
- To install, tighten to 25 Nm (18 lb-ft).

5. NOTE: Spot welding the bumper is not required for installation.

To install, reverse the removal procedure.