Front Door Window Regulator: Service and Repair

FRONT DOOR WINDOW REGULATOR AND MOTOR






Removal and Installation
1. Remove the front door speaker.
2. Remove the side impact bolster.
3. Position the door latch release handle aside.

4. CAUTION: Do not touch the adhesive surface, as re-bonding will be impaired.

Remove the watershield.

5. If manual window regulator, connect the window regulator handle; if power, connect the door glass operating switch electrical connector.
6. Remove the 2 door window glass clamp bolts.
- To install, tighten to 8 Nm (71 lb-in).

7. Hold the window glass at the top of the opening, lower the regulator and remove the window glass from the regulator.

8. CAUTION: Make sure the window glass is adequately supported at the top of the opening.

Using suitable hooks, raise and secure the window glass.

9. Remove the 7 bolts and the window regulator and motor.
- To install, tighten to 7 Nm (62 lb-in).

10. To install, reverse the removal procedure.