Transmission Selector Lever

Transmission Selector Lever

Material:

Removal
1. Remove the floor console. For additional information, refer to Console.





2. Remove the selector lever cable from the selector.
1 Shift the selector lever to "P".
2 Unclip the selector lever cable.
3 Unclip the selector lever cable outer sleeve.





3. Disconnect the selector lever assembly electrical connector.





4. Remove the selector lever assembly.
^ Remove the 4 nuts.

Installation





1. NOTE: Use thread sealant for the nuts.

Install the selector lever assembly.
^ Install the 4 nuts.
^ Tighten to 9 Nm (80 inch lbs.).





2. Connect the selector lever assembly electrical connector.





3. NOTE: The selector lever has its own detent mechanism. Holding the selector lever is not necessary.

Install the selector cable to the selector lever.
1 Shift the selector lever to "P".
2 Clip in the selector lever cable outer sleeve.
3 Clip in the selector lever cable.
4. Install the floor console. For additional information, refer to Console.
5. Adjust the selector lever cable.