Brake Caliper Anchor Plate, Rear

Brake Caliper Anchor Plate





Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.





2. Remove the park brake cable from the brake caliper.
1. Pull back the parking brake lever.
2. Disconnect the cable from the parking brake lever.
3. Remove the cable conduit retaining clip.
4. Remove the park brake cable from the brake caliper.

3. CAUTION: Do not allow the brake caliper to hang from the hose or damage to the hose can occur.

Remove the 2 brake caliper bolts and position the caliper aside.
^ Support the brake caliper with mechanic's wire.
^ To install, tighten to 35 Nm (26 ft. lbs.).
4. Remove the brake pads.
5. Remove the 2 brake caliper anchor plate bolts and the anchor plate.
^ To install, tighten to 55 Nm (41 ft. lbs.).
6. To install, reverse the removal procedure.