Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION (CMP) SENSOR







Removal and Installation
1. Disconnect the battery ground cable.
2. Disconnect the 2 camshaft position (CMP) sensor electrical connectors.
3. Remove the ground strap nut and position the ground strap aside.
- To install, tighten to 10 Nm (89 lb-in).

4. Remove the 3 nuts and position the wiring harness conduit aside.
- To install, tighten to 8 Nm (70 lb-in).

5. Remove the 2 bolts and the LH and RH CMP sensors.
- To install, tighten to 10 Nm (89 lb-in).
- Inspect and install new O-ring seals as necessary.

6. NOTE: Lubricate the O-ring seals with clean engine oil.

To install, reverse the removal procedure.