Front Seat

FRONT SEAT







Removal

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is irritating to the skin. Wash your hands with soap and water afterwards.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- If a side air bag deployment took place, a new backrest foam pad, trim cover and side air bag module must be installed. The backrest frame should be replaced if necessary.
- Driver seat shown, passenger seat similar.

1. Remove the 2 seat track-to-floor bolts.
2. Move the seat to the most FORWARD position.
3. Depower the SRS.







4. Remove the 2 seat track-to-floor nuts.
5. Remove the safety belt from the seat guide, disconnect the seat electrical connectors and carefully remove the front seat from the vehicle.

Installation
1. Position the seat in the vehicle and connect the seat electrical connectors.
2. Install the 2 seat track-to-floor nuts.
- Tighten to 47 Nm (35 lb-ft).

3. Repower the SRS.
4. Move the seat to the most rearward position.
5. Install the 2 seat track to floor bolts.
- Tighten to 47 Nm (35 lb-ft).

6. Position the safety belt back into the seat guide.
- Make sure the safety belt is not twisted after installation.

7. Check the active restraint system for correct operation.