Console: Service and Repair

FLOOR CONSOLE







Removal and Installation
1. Apply the parking brake.
2. Place the transmission selector lever in NEUTRAL.
3. Release the lower instrument panel finish panel.
4. Release the floor console finish panel assembly by pulling upward from the front.
5. Release the parking brake boot from the console base.
6. Remove the 2 floor console assembly front screws.
7. Remove the 2 floor console assembly rear bolts.
- To install, tighten to 8 Nm (71 lb-in).

8. Remove the floor console assembly rear nut.
- To install, tighten to 8 Nm (71 lb-in).

9. Remove the floor console assembly by sliding it rearward.
10. To install, reverse the removal procedure.