Windshield Glass

WINDSHIELD GLASS







Removal

WARNING: To prevent glass splinters from entering eyes or cutting hands, wear safety glasses and heavy gloves when cutting glass from the vehicle. Failure to follow these instructions may result in personal injury.

1. Remove the cowl vent screen.

2. CAUTION: Care must be taken to prevent scratching the pinch weld.

NOTE: Lubricate the existing urethane adhesive with water to aid the tool while cutting.

Using an appropriate tool, starting at the bottom corner of the windshield glass, cut the urethane adhesive from the glass.

3. Remove the windshield glass.
4. Using a soft brush or vacuum, clean the pinch weld.

Installation

CAUTION: After installing the urethane installed windshield glass, the vehicle should not be driven until the urethane adhesive has cured. The curing time at temperatures above 13°C (55°F) and relative humidity above 50% is 12-24 hours. Refer to the ESSEX drive away chart for cure times as temperatures and humidity may vary. Inadequate curing of the urethane adhesive may adversely affect the strength of the urethane adhesive bond.

1. Dry-fit the windshield glass by centering it side-to-side and by adjusting the setting blocks (if equipped) to get the correct position of the part top-to-bottom. Make alignment marks with tape or non-staining grease pencil on both the glass and the vehicle body.







2. CAUTION: Care must be taken to avoid scratching the pinch weld.

Trim the remaining urethane adhesive on the pinch weld using only the full-cut method. In this method, most of the existing urethane is removed leaving a level bead around the entire pinch weld.

3. Using a wool applicator, apply the urethane metal primer to any exposed metal on the pinch weld. Allow 6 to 10 minutes to dry.
4. If reinstalling the original windshield glass, remove the urethane adhesive from the windshield glass.

5. NOTE: If a new windshield glass is to be installed, attach the new moulding to the edge of the glass starting at the top center then work down the sides and around the corners.

If installing a new windshield glass, clean the inside of the glass surface with an alcohol-free cleaner to make sure the ceramic-coated area is clean.

6. CAUTION: Wipe off the urethane glass prep immediately after each application because it flash dries. Apply deliberate strokes, making sure not to overlap the applied area.

If installing a new windshield glass, apply urethane glass prep twice around the class surface to be prepped.

7. If installing a new windshield glass, apply urethane glass primer to the same area referred to in the previous step. Allow 5 minutes to dry.







8. Cut the applicator tip to specification.







9. Apply a bead of urethane adhesive to the pinch weld.

10. CAUTION: Open a window to prevent the windshield glass from being pushed out by air pressure when the door is closed.

Using the alignment marks, install the windshield glass.

11. After the glass is set, check for water leaks and add urethane adhesive where needed.
12. Install the cowl vent screen.